Chicago Electric 66603 Set Up, Operating, And Servicing Instructions page 13

3. To add engine oil, unscrew and remove the Oil Dipstick (65A). Pour engine oil into
the oil fill hole until the level of oil is even with the bottom edge of the oil fill hole (if
you cannot see the oil through the oil fill hole, then the oil is too low and more oil
must be added). Then, make sure to screw the Oil Dipstick back into its Dipstick
Hole. (see Figure D.)
ThIs GENERAToR hAs AN AUTo-shUTDowN oIl sENsoR. IF ENGINE sTops
oR wIll NoT sTART, chEcK oIl lEvEl.
4. To fill the Fuel Tank (31), unscrew and remove the Fuel Tank Cap (34). Fill the
Fuel Tank with mid-to-high octane unleaded gasoline. Then replace the Fuel
Tank Cap. When necessary, refill the Fuel Tank. (see Figure E.)
5. Periodically, check the Fuel Filter (32) for excessive dirt and debris. If necessary,
remove the Fuel Filter and clean with compressed air. (see Figure E.)
SKU 66603 For technical questions, please call 1-800-444-3353.
FUEl vAlvE (41)
FIGURE F
choKE lEvER (21A)
Page 13