JVC TH-A5 Service Manual page 5

Disassembly method
Removing the top cover
1. Remove the four screws A attaching the top cover
on the both sides of the body.
2. Remove the two screws B on the back of the body.
3. Remove the top cover from behind in the direction of
the arrow while pulling both sides outward.
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover.
1. Remove the one screw a and remove the earth wier.
2. Remove the three screws C attaching the front panel
assembly on the bottom of the body.
3. Remove the two screws D attaching the front panel
assembly on the both sides of the body.
4. Remove the claw1, claw2 and claw3, and detach the
front panel assembly toward the front.
5. Disconnect the card wire from the connector DW20
on the DSP board.
Removing the power cord
Prior to performing the following procedure, remove
the top cover.
1. Disconnect the power cord from the connector CW1
on the main board and pull up the cord stopper
upward.
Notes : The power cord is exchangeable.
Tie band
Rear panel
Fig.4
(See Fig.1)
(See Fig.2A, 2B and 3)
(See Fig.4)
Power cord
CW1
Power cord
stopper
Top cover
A
2
Front panel assembly
C
Claw1
(bottom side)
Fig.2A
Front panel
assembly
Claw2 (both side)
D
(both side)
(fixing the earth wire)
DSP board
DW20
Front panel assembly
(Inner side)
B
Fig.1
C
Claw3
a
Fig.2B
Display board
Fig.3
TH-A5
1-5