Programming Tv Channels; Picture Settings - Grundig Accoro 102 Service Manual

ACCORO 102
#$
%$$
%$$
EXIT
14
!
$
*+
EXIT
GRUNDIG Service
SETTINGS
__________________________________________________________________________________

Programming TV channels

The TV set is equipped with an automatic tuning system.
When the automatic tuning function is completed, you can sort the found TV
channels to suit your taste.
If you connect a GRUNDIG video recorder which is equipped with the MEGA-
LOGIC system to this TV set using the Megalogic EURO/AV (Scart) cable
supplied with the video recorder, programming of TV channels on the video
recorder is no more required.
For more information, see page 40, chapter "The GRUNDIG Megalogic
System".
Programming TV channels using the automatic
tuning system
1
Call up the Dialog Center using the »Menu« button.
2
Select the »
s
3 Select »System« using the »
select the transmission standard: »B/G« for Continental Europe, »D/K« for
East Europe, »I« for Great Britain, »L1 (12)« or »L2 (8)« for France.
!
4 Select »Auto tune« using the »
&!
– The »AUTO TUNE« screen appears.
5 – Press »OK« to start the automatic tuning system. Depending on the
number of receivable channels, the channel search may take one minute
or longer.
– When the automatic channel search is completed, the TV set switches to
channel position 1 and the programme list appears on the picture screen.
SETTINGS
__________________________________________________________________________________
Storing the found TV channels
1
Select the TV channel which is to be stored on channel position 1 using the
» « or »
2
Select the TV channel which is to be stored on channel position 2 using the
» « or »
3
Repeat the same procedure until all found TV channels are stored.
4 Press the »Exit« button to end the setting.

Picture settings

1
Call up the Dialog Center using the »Menu« button.
2 Select the »
s
3 Select the »Contrast«, »Brightness«, »Colour«, »Tint« or »Sharpness« row
using the »
4
Change the setting using the » « or » « button then confirm with »OK«.
5
Select »Scan mode« using the »
» « button to select »100 Hz« or »Natural« (= On) .
6 Select »DNR« (noise reduction) using the »
» « or » « button to select »OFF« or »AUTO«.
7 Press the »Exit« button to end the setting.
« menu using the » « or » « button.
« button, then use the » « or » « button to
« button then confirm with » «.
« button then press »OK« to store the channel.
« button then press »OK« to store the channel.
« menu using the » « or » « button.
« or » « button.
« or » « button then use the » « or
« or » « button then use the
Allgemeiner Teil / General Section
15
1 - 17