Configuring Default Endpoint Settings - Cisco TelePresence 7010 Help Manual

Configuration

Configuring default endpoint settings

The Default endpoint settings
default endpoint.
To access this information, go to
To update the defaults, or change the configuration, edit the fields referring to the table below for details and
click Apply changes.
Note: Configuration changes in the Default endpoint settings page affect active calls unless the call or
conference has already been manually changed via the
appropriate endpoint.
Table 27: Default endpoint settings
Field Field description
Allow stereo This option enables stereo audio in calls with
audio compatible endpoints.
Use *6 to mute Check the box to enable endpoints to mute or
audio unmute their audio using the *6 keypad
combination.
Full screen This option determines how single-camera
view of single- endpoints are viewed on the conference
screen display sent to multi-screen endpoints.
endpoints
Select a setting from the drop-down list to set
as the default for new endpoints:
Allowed: The stream from a single-camera
n
endpoint is allowed to display in a full
screen pane when the conference is
viewed on a multi-screen endpoint.
Dynamic: As for Allowed if there are no
n
grouped endpoints to display on the multi-
screen endpoint.
When there are grouped endpoints to
show on the multi-screen endpoint, the
stream from a single-camera endpoint will
be restricted to displaying as a smaller,
continuous presence pane.
Disabled: The stream from a single-camera
n
endpoint will never be shown as a full
screen pane on a multi-screen endpoint.
Cisco TelePresence Server 7010 and MSE 8710 in Locally Managed Mode Printed Help (4.0)
page allows you to configure the TelePresence Server settings for the
Configuration > Default endpoint
Advanced settings
settings.
and Configuration
Usage tips
The default is enabled.
However, some endpoints do not support
stereo echo cancellation and in some
circumstances this can cause echo. If
necessary, disable this option to prevent the
use of stereo audio, either for a specific
endpoint or by default.
We recommend that you enable this if
endpoints can be muted on the TelePresence
Server but do not support controlling the mute
setting via ActiveControl.
This setting can be overridden by the
equivalent Full screen view setting in single-
screen endpoints' Configuration
We recommend using the default setting,
which is Allowed.
pages for the
page.
Page 42 of 132