Configuring Sip Settings - Cisco TelePresence 7010 Help Manual

Configuration

Configuring SIP settings

The SIP settings page allows you to control the TelePresence Server SIP settings.
To access this information, go to
To update the defaults, or change the configuration at any time, edit the fields referring to the table below for
details and click Apply changes.
Table 25: SIP
Field Field description
Outbound call This setting affects outgoing SIP calls and
configuration registration. The options are:
Use registrar enables SIP registration and
routes outbound SIP calls via the registrar.
Use trunk disables SIP registration and tears
down existing registrations. Routes outbound
calls to the trunk destination, e.g. VC S or
C U C M.
Call direct disables SIP registration and tears
down existing registrations. Outbound
SIP calls go directly (not via registrar or trunk).
Outbound The hostname or IP address of the SIP
address registrar or trunk destination.
Cisco TelePresence Server 7010 and MSE 8710 in Locally Managed Mode Printed Help (4.0)
Configuration > SIP settings.
Usage tips
Use registrar:
Enables SIP registrations, on a system-wide
n
basis, with the registrar address you provide.
Outgoing calls always go through the
n
registrar, unless you explicitly choose Call
direct for a pre-configured endpoint or ad
hoc call.
An outbound call will fail if the registrar does
n
not respond.
Incoming calls should come through the
n
registrar and will fail if the registrar does not
respond.
Use trunk:
Directs outbound SIP calls via the trunk to
n
the SIP server address you provide.
The SIP server, for example Cisco Video
n
Communication Server (VCS) or Cisco
Unified Call Manager (CUCM), is
responsible for the onward routing of
outbound SIP calls from the TelePresence
Server.
Call direct:
The TelePresence Server will connect SIP
n
calls directly if possible. It does not use the
Outbound address or Outbound domain
parameters.
The TelePresence Server does not attempt
n
to use either the registrar or trunk.
The TelePresence Server ignores this field if
Outbound call configuration is set to Call
direct.
Page 38 of 132