Advertisement
Tabletop installation
Two one-line wall jacks
If there are two one-line wall jacks, use both long line cords. Plug one end
of the clear line cord into the jack labeled L1 or L1/L2 on the back of the
telephone base. Then, plug the other end into the wall jack for Line 1. Plug
one end of the black line cord into the jack labeled L2 or DATA on the back
of the telephone base. Then, plug the other end into the wall jack for Line 2.
Make sure the line cords are plugged firmly into the telephone base and the
wall jack.
Line 1
GHI
PQRS
NOTE: This product is designed to operate optimally with two telephone lines.
If you choose to install only one telephone line, the telephone will continue to
operate normally as long as the unused line is not selected. If you experience diffi-
culty, make sure you have pressed the correct LINE key.
Line 2
L2 or DATA
DEF
ABC
JKL
MNO
TUV
WXYZ
OPER
MIC
1. Connect the line cords to the
telephone base and wall jacks.
2. Plug one end of the coiled handset
cord into the handset. Plug the
other end into the jack on the left
side of the telephone base.
3. To determine which line is in use,
press LINE 1 and call one of the
telephone numbers. If there is a
busy signal, Line 1 is the number
you called. If Line 2 rings, it is
the number you called.
Advertisement
