Basic Copy Modes; Before Using Copying Functions; Default Settings; Confirming The Set Functions - Oki MB760dnfax Basic Manual

●

BASIC COPY MODES

Before Using Copying Functions

Default settings

This equipment is under its "default settings" when the power is
turned ON, namely, if no setting change has been applied yet,
the equipment's settings return to the default ones when the
energy saving mode is cleared or the [RESET] button on the
control panel is pressed. The default settings for basic copy
modes at installation are shown below.
Item
Reproduction ratio
Copy quantity
Paper selection
Simplex/Duplex
Density adjustment
Original mode
Finishing mode
Feeding mode when using the
RADF
The default settings are changeable.

Confirming the set functions

If you press [SETTINGS] on the touch panel, the menu shown
below is displayed. On this menu, you can view the functions
that are currently set.
Default setting
100%
1
Automatic Paper Selection
(APS)
1-sided original -> 1-sided copy
Automatic adjustment
TEXT/PHOTO
When using the original glass:
NON-SORT NON-STAPLE
When using the RADF
(Reversing Automatic Document
Feeder):
SORT
Continuous feed mode
Switching to the function setting menu
To change the functions on the current menu, press the
corresponding buttons. The desired setting menu will then
appear.

Clearing the set functions

If you want to clear any copy function setting, press [RESET]
on the corresponding setting menu.
Clearing all settings changed
When you press the [RESET] button on the control panel, all
the function changes will be cleared.
Even if you do not do so, the changes will be cleared if the
equipment is left idle for 45 sec. (default setting).

Restrictions on function combinations

Several copy functions can be used together. However some
functions may not be used with other ones. For details, see the
following Guide:
 Advanced Guide
- 43 -
BASIC COPY MODES
1
2
3
4
5
6