Brother HL-2030 Service Manual page 163

CHAPTER 6 ADJUSTMENTS AND UPDATING OF SETTINGS,
REQUIRED AFTER PARTS REPLACEMENT
Setting the serial number
1) Make sure that the power supply of the printer is turned ON.
2) Double-click the brmainte.EXE file (maintenance utility) which has been copied in the
"hl2000" folder to start.
3) Select Input Information from Menu. Select the applicable model name.
4) Check the port (USB) which the printer is connected through and click "Serial No." in the
lower box.
Enter the serial number (the last nine digits) of the printer into the box at the right hand
side. The serial number is shown in the window, and check that it is correct. Follow the
next step without clicking the OK button.
Inputting the adjusted value of the laser scanner
1) Select 'Adjust Scanner' from Menu. Enter the figures (the last four digits) shown on the
label attached on the chassis at the right hand side of the main PCB into the box at the
right hand side.
Follow the next step without clicking the OK button.
Fig. 6-2
Fig. 6-3
6-4
Confidential