Error Message In The Status Monitor - Brother HL-2030 Service Manual

3.2

Error Message in the Status Monitor

The Status Monitor will report problems with the printer. Take the corrective actions listed in
the following table for the error message that the Status Monitor reports.
The default setting for the Status Monitor is off. If you would like to turn the status monitor on,
you can change the setting of the Status Monitor in the Device Options of the Advanced tab.
Error message
Cover is open
Back Cover is open
Memory Full
Print Overrun
No Paper Fed Tray
No Paper Fed Manual slot
Paper Jam Tray 1
Paper Jam Inside
Paper Jam Rear
Toner Life End
Toner Low
Cartridge Position Error
• Close the front cover of the printer.
•
Close the back cover of the printer.
•
Press the Go button to print the data remaining in the
printer. Cancel the print job if you want to delete the data
remaining in the printer.
•
Reduce the print resolution or reduce the complexity of
your document.
•
Press the Go button to print the data left in the printer.
Cancel the print job if you want to delete the data
remaining in the printer.
•
If this does not clear the error, reduce the complexity of
your document or reduce the print resolution.
•
Set page protection to AUTO by using the supplied
®
Windows driver or RPC program.
•
Change the following settings in the supplied Windows
driver and try again. The best combination of these
settings will vary depending on your document:
•
Graphics Mode
•
TrueType mode
•
Use Printer TrueType
•
The paper tray may be out of paper or not properly
installed. If it is empty, put a new stack of paper in the
paper tray and then press the Go button.
• If there is paper in the paper tray, make sure it is straight.
If the paper is curled, straighten it before printing.
Sometimes it is helpful to remove the paper, turn the
stack over and put it back in the paper tray.
•
Reduce the amount of paper in the paper tray, and then
try again.
•
Make sure you use paper that meets Brother's
recommended paper specifications.
Chapter 1.
•
Take out the jammed paper from the indicated area.
See 4.2 'Paper Jams' in this Chapter.
•
See 1.2 'Toner Cartridge' in Chapter 5.
•
Purchase a new toner cartridge and have it ready for when
the Toner Life End status is indicated.
•
Take out the toner cartridge and put it back into the printer
again.
7-7
HL-2030/2040/2070N SERVICE MANUAL
Remedy
®
Fonts
See 3.6 'Paper' in
®
Confidential