Error Message; Error Message In The Status Monitor - Brother HL 5030 - B/W Laser Printer Service Manual

CHAPTER 6 TROUBLESHOOTING
3.

ERROR MESSAGE

3.1

Error Message in the Status Monitor

The Status Monitor will report problems with the printer. Take the corrective actions listed in
the following table for the error message that the Status Monitor reports.
The default setting for the Status Monitor is off. If you would like to turn the status monitor on,
you can change the setting of the Status Monitor in the Device Options of the Advanced tab.
Error message
Front Cover Open
Jam Clear Cover Open
Memory Full
No Paper Tray1
No Paper Tray2
No Paper Manual Feed
No Paper Multi Purpose Tray
Jam Tray 1
Jam Tray 2
Jam Inside
Jam Rear
Jam Multi Purpose Tray
Print Overrun
•
Close the front cover of the printer.
•
Close the jam clear cover of the printer. See page 6-12.
•
Press the Go button to print the data remaining in the
printer.
Press the Job Cancel button if you want to delete the data
remaining in the printer.
•
Reduce the print resolution or reduce the complexity of
your document.
•
Expand the printer memory by adding a commercially
available DIMM memory module.
•
The paper tray may be out of paper or not properly
installed. If it is empty, put a new stack of paper in the
paper tray. For HL-5030, put paper in the paper tray and
then press the Go button.
•
If there is paper in the paper tray, make sure it is
straight. If the paper is curled, straighten it before
printing. Sometimes it is helpful to remove the paper, turn
the stack over and put it back in the paper tray.
•
Reduce the amount of paper in the paper tray, and then
try again.
•
Make sure you use paper that meets Brother's
recommended paper specifications. See 3.5 PAPER in
Chapter 1.
•
Take out the jammed paper from the indicated area.
See 4. PAPER PROBLEMS in this chapter.
•
Press the Go button to print the data left in the printer.
Press the Job Cancel button if you want to delete the data
left in the printer.
•
If this does not clear the error, reduce the complexity of
your document or reduce the print resolution.
•
Expand the printer memory by adding a commercially
available DIMM memory module. Set page protection to
ON by using the supplied Windows driver or RPC
program.
•
Change the following settings in the supplied Windows
driver and try again. The best combination of these
settings will vary depending on your document:
Graphics Mode
TrueType™ mode
Use Printer TrueType™ Fonts
6-6
Remedy