HP xw4600 Service And Technical Reference Manual page 106

4. Push the drive into the selected bay until it snaps into place (1).
Figure 4-50
5. Attach the power (2) and data (3) cables to the SAS drive.
6. Insert the SAS controller card into an available PCI slot in the workstation chassis.
7. Connect the data cable from the hard drive (1) to the controller card (2).
Figure 4-51
8. If necessary, install the SAS card in an empty PCI Express slot, and then install the LED cable from
the card to the system board. You can find the location of this connector on the service label on
the inside of the side access panel.
NOTE: To install three or four SAS drives, install the third and fourth drives in the workstation optical
drive bays. See
instructions.
98 Chapter 4 Removal and replacement procedures
Installing the SAS hard drive
Connecting the SAS cable to SAS hard drive
Installing SATA hard drives in the optical drive bays (optional) on page 102 for
ENWW