Installing An Optical Drive (Minitower Configuration) - HP xw4600 Service And Technical Reference Manual

3. Lift the green drive-lock release lever (1) and gently slide the drive out of the chassis (2).
Figure 4-38
4. After removing the optical drive (1), if you plan to install another drive, remove only the four guide
screws from the drive casing (2).
Figure 4-39

Installing an optical drive (minitower configuration)

1. Disconnect power from the system
access panel
(Removing the front bezel on page
ENWW
Removing the optical drive from the chassis
Removing the optical drive screws
(Predisassembly procedures on page
(Removing the side access panel on page
68).
58), remove the side
64), and then remove the front bezel
Removing and replacing components 91