Assembly And Set-Up; Attaching The Front Wheel - Razor RipRider 360 Owner's Manual

ASSEMBLY AND SET-UP

q Attaching the Front Fork
Required Tools: 13mm open wrench and 5mm allen wrench
1
Remove the steering bolt and
locknut from the frame assembly
with a 13mm open wrench and
5mm allen wrench.
4
Re-insert the steering bolt
and secure with locknut using a
13mm open wrench and 5mm allen
wrench.
q Attaching the Front Wheel
Required Tools: 5mm allen wrench and 10mm open wrench
1
Remove the four coupling
bolts from the front fork with a
5mm allen wrench and 10mm
open wrench.
2
Insert the front fork into the
frame assembly.
2
Insert the wheel assembly into
the front fork assembly and align
holes.
3
Be sure to properly align slot in
headset tube with pin on fork as
shown.
3
Re-insert the coupling bolts
through the front fork and secure
with allen wrench and open
wrench.
WARNING: Failing to
properly tighten the steering bolt
that attaches the handlebars can
cause you to lose control and fall.