Attaching The Front Fork; Attaching The Pedals And Front Wheel; Assembly And Set-Up - Razor RipRider 360 Owner's Manual

ASSEMBLY AND SET-UP

❑ Attaching the Front Fork

1
Remove the steering bolt and
locknut from the frame assembly
with a 13mm open wrench and
5mm hexagonal wrench.
4
Re-insert the steering bolt and
secure with locknut using a 13mm
open wrench and 5mm hexagonal
wrench.

❑ Attaching the Pedals and Front Wheel

1
Install the left pedal into the
crank marked (L). Tighten with
15mm open end wrench. Repeat
step for right pedal and crank.
4
Re-insert the Allen socket
screws through the front fork and
secure with nuts. Tighten nuts with
a 10mm open wrench and 5mm
hexagonal wrench.
2
Insert the front fork assembly
into the frame assembly.
2
Remove the four Allen socket
screws and nuts from the front
fork with a 10mm open wrench
and 5mm hexagonal wrench.
3
Be sure to align slot in headset
tube with pin on fork properly as
shown.
3
Insert the wheel assembly into
the front fork assembly and align
holes.
Note: Refer to R (right) and L (left)
stickers on pedals for orientation.
3
WARNING: Failing to
properly tighten the steering bolt
that attaches the handlebar can
cause you to lose control and fall.
WARNING: Failing to
install the correct pedal on the
correct crank (left and right) can
cause the pedal to strip.