Tmba - Siemens SATURN IIE EPABX Installation Test Procedures

Epabx

Table of Contents

SATURN IIE EPABX

Installation Test Procedures

S T E P

Check that the cabinet ac power cord is not connected to an

electrical outlet.

Check that the -48Vdc power supply is strapped for

Check that all circuit breakers on the Power System Unit

(PSU) are in the OFF position and fuses inserted.

If the MSM is installed, check that the Battery Packk is not

connected but inserted into corresponding position. Also

check that the PSU is strapped for MSM operation.

Check that each PCB in the system is withdrawn from its

backplane connector.

Check that the DIP switch settings for the CIOP board are set

to meet the operating characteristics of the particular data

service terminal to be used to input the installation-dependent

base) into system memory when the standard

data base format is supplied with the SATURN IIE System.

Check that each trunk-type PCB (i.e., T M E M , TMIE, TMBA-2

and/or TMBA-4) is properly strapped according to the

operating characteristics of the trunk facility of the Central

Office (CO) or distant PABX.

that the intercabinet signal and power/ground cabling

arrangements are complete and all connectors are firmly seat-

ed according to the referenced illustrations (Figures 2.00

through 2.03).

Check that Berg Clips are on pins 27 and 28 of unused

signal cable connectors on basic shelf.

Table 2.01 Visual Inspection

VISUAL INSPECTION

Issue 1, May 1986

REFERENCE

SATURN IIE EPABX Installation