Connecting Onkyo  Components - Onkyo TX-8050 Instruction Manual

Connecting Your Components
Connecting Onkyo  Components
1 Make sure that each Onkyo component is
connected with an analog audio cable
6
(connection in the hookup examples)
( page 15).
Make the  connection (see the
2
illustration).
With  (Remote Interactive), you can use the
following special functions:
■ System On/Auto Power On
When you start playback on a component connected via
, while the receiver is on Standby, the receiver will
automatically turn on and select that component as the
input source.
■ Direct Change
When playback is started on a component connected via
, the receiver automatically selects that component as
the input source.
■ Remote Control
You can use the receiver's remote controller to control
your other -capable Onkyo components, pointing the
remote controller at the receiver's remote control sensor
instead of the component.
Notes:
• Use only  cables for  connections.  cables
are supplied with Onkyo players (CD, etc.).
• Some components have two  jacks. You can
connect either one to the receiver. The other jack is for
connecting additional -capable components.
16
En-
—Continued
Analog
audio cable
e.g., CD player
 cable
• Connect only Onkyo components to  jacks.
Connecting other manufacturer's components may
cause a malfunction.
• Some components may not support all  functions.
Refer to the manuals supplied with your Onkyo
components.
• While Zone 2 is on, the System On/Auto Power On
and Direct Change  functions do not work.
Analog
audio cable
e.g., Tape deck
 cable