Connecting; Capable Onkyo Components; Connecting The Power Cord - Onkyo TX-SR573 Instruction Manual

Connecting Your Components

Connecting

-capable Onkyo Components

Step 1: Make sure that the Onkyo component is connected to the AV receiver with an analog audio cable (RCA).
Step 2: Make the
connection.
With (Remote Interactive) you can use the following special
Auto Power On/Standby
When you start playback on a component connected via
on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components
connected via will also go on Standby. This function will not work with components whose power cord is connected
to the AV receiver's AC OUTLET.
Direct Change
When playback is started on a component connected via
the input source. If your DVD player is connected to the AV receiver's multichannel DVD input, you'll need to press
the [MULTI CH] button to hear all channels (page 35), as the Direct Change function only selects the FRONT jacks.
Remote Control
You can use the AV receiver's remote controller to control your other
remote controller at the AV receiver's remote control sensor instead of the component. You must enter the appropriate
remote control code first (page 55).
Notes:
• Use only cables for
cables are supplied with Onkyo players (DVD,
CD, etc.).
• Some components have two
connect either one to the AV receiver. The other
jack is for connecting additional
components.
• Connect the AV receiver's
components. Connecting to other manufacturer's
components may cause them to malfunction.
• Some components may not support all
tions. Refer to the manuals supplied with your
other Onkyo components.
• If you connect an Onkyo MD recorder, CD
recorder, or next generation HDD-compatible
component, you must change the input display
(see page 31).

Connecting the Power Cord

• Before connecting the power cord, connect all of your speakers and AV components.
• Connect the AV receiver's power cord to a suitable wall outlet.
• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.
, if the AV receiver is on Standby, it will automatically turn
connections.
jacks, you can
-capable
jack only to Onkyo
func-
functions:
, the AV receiver automatically selects that component as
-capable Onkyo components, pointing the
REMOTE
CONTROL
e.g., CD player
e.g., DVD player
IN
L
R
CD
FRONT
L
R
DVD
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
29