Life Fitness 9500HR User Manual page 11

H U T L
OW TO SE HE
The patented Lifepulse digital heart rate sensors are the default heart rate monitoring
system on the Life Fitness 9500HR treadmill. To use the Lifepulse sensors, simply
grasp the stainless steel sensors when the display console prompts you to do so or any-
time you wish to check your heart rate. There are four sensors, two on each side of the
handrail, and you must make contact with all four to obtain your heart rate. The console
will display your ECG-accurate heart rate in 10 to 30 seconds.
CAUTION: DO NOT ATTEMPT TO GRASP THE LIFEPULSE SENSORS AT
SPEEDS ABOVE 4.5 MPH (7.2 KPH).
ATTENTION: NE METTRE PAS LES MAINS SUR LES ELECTRODES LIFEPULSE
EN VITESSE AU-DESSUS 4.5 (7.2 KPH).
H U T H
OW TO SE HE
Wet the electrodes of the transmitter (the two grooved surfaces on the underside of the
strap) and secure the strap as high under the chest muscles as possible. The strap
should be snug, but comfortable enough to allow for normal breathing.
The transmitter strap will deliver an optimum
heart rate reading when the electrodes are
directly in contact with bare skin. It will also,
however, function properly through wet,
lightweight clothing. The key is for the
electrodes to remain wet so that
they can conduct the electrical
impulses of the heart back to
the receiver.
If it becomes necessary to
remoisten the chest strap transmitter,
grasp the center of the strap, pull it
away from the chest to expose the two
electrodes, then moisten them in this
position.
D H
IFEPULSE IGITAL
R Z T
EART ATE ONE
Zone Trainer chest strap transmitter
R S
EART ATE ENSORS
C S
RAINER HEST TRAP
11