Advertisement
[MC Test Mode]
• This mode is used to check operations of the respective sections
of Amplifier, Tuner, CD and Tape.
Procedure:
Press ?/1 button to turn the set ON.
1.
Press the three buttons of x , DISPLAY and DISC 3
2.
simultaneously.
3.
A message "TEST MODE" appears on the FL display tube.
4.
When the joy stick is pushed up, GEQ increases to its
maximum and a message "GEQ MAX" appears.
5.
When the joy stick is pushed down, GEQ decreases to its
minimum and a message "GEQ MIN" appears.
6.
When the joy stick is pushed left or right, GEQ is set to flat
and a message "GEQ FLAT" appears.
7.
When the VOLUME control knob is turned clockwise even
slightly, the sound volume increases to its maximum and a
message "VOLUME MAX" appears for two seconds, then the
display returns to the original display.
8.
When the VOLUME control knob is turned counter-clockwise
even slightly, the sound volume decreases to its minimum and
a message "VOLUME MIN" appears for two seconds, then
the display returns to the original display.
9.
In the test mode, the default-preset channel is called even when
the TUNER is selected and an attempt is made to call the preset
channel that has been stored in memory, by operating the .
and > buttons. (It means that the memory is cleared.)
10. When a tape is inserted in Deck B and recording is started, the
input source function selects VIDEO automatically.
11. When x button is pressed to stop recording, the Deck B is
selected and tape is rewound using the m button, tape is
rewound, tape is stops at around the record-starting position
and playback of the recorded portion of the tape is started. If
PAUSE is inserted even once during recording, tape is rewound
to the position around the PAUSE position and is played back.
12. When the HI-DUB Button is press during playback of Deck
B, either normal speed or high speed can be selected by this
button.
13. Select the desired loop as follows. Press the MODE SELECT
button and press the PUSH ENTER button in the "Set Up
Mode". Push the joy stick to right or left and press the PUSH
ENTER button in the "Direction Set Up". Push the joy stick
to right or left and press PUSH ENTER at "Cycle". Insert a
test tape AMS-110A or AMS-RO to Deck A.
14. Press the CD SYNCHRO button to enter the AMS test mode.
15. After a tape is rewound first, the FF AMS is checked, and the
mechanism is shut off after detecting the AMS signal twice.
16. Then the REW AMS is checked and the mechanism is shut off
after detecting the AMS signal twice.
17. When the check is complete, a message of either OK or NG
appears.
18. When you want to exit this mode, press the ?/1 button twice.
The cold reset is enforced at the same time.
6
Hide quick links:
Advertisement
Chapters
