Audio Settings - Kenwood KMM-100 Instruction Manual

AUDIO SETTINGS

While listening to any source...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [AUDIO CTRL], then press the knob.
3
Turn the volume knob to make a selection (see the following table), then press the knob.
3
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
(or using RC-406)
1
Press AUD to enter [AUDIO CTRL].
Press 5/∞ to make a selection, then press ENT 38.
2
• To return to the previous hierarchy, press
SUB-W LEVEL –15 to +15 (0):
BASS LEVEL –8 to +8 (0):
MID LEVEL –8 to +8 (0):
TRE LEVEL –8 to +8 (0):
PRESET EQ NATURAL/ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ POWERFUL: Selects a preset equalizer
suitable to the music genre. (Select [USER] to use the customized bass, middle, and treble settings.)
BASS BOOST B.BOOST LV1/ B.BOOST LV2/ B.BOOST LV3: Selects your preferred bass boost level. ;
OFF: Cancels.
LOUDNESS LOUD LV1/ LOUD LV2: Selects your preferred low and high frequencies boost to produce a well-
balanced sound at a low volume level. ; OFF: Cancels.
BALANCE L15 to R15 (0): Adjusts the left and right speaker output balance.
FADER R15 to F15 (0): Adjusts the rear and front speaker output balance.
SUB-W SET ON: Turns on the subwoofer output. ; OFF: Cancels.
DETAIL SET
LPF SUB-W THROUGH: All signals are sent to the subwoofer. ; 85HZ/ 120HZ/ 160HZ: Audio signals with
frequencies lower than 85 Hz/ 120 Hz/ 160 Hz are sent to the subwoofer.
SUB-W REV (180°)/ NORM (0°): Selects the phase of the subwoofer output to be in line with the speaker
PHASE output for optimum performance. (Selectable only if a setting other than [THROUGH] is selected for
[LPF SUB-W].)
SUPREME ON: Creates realistic sound by interpolating the high-frequency components that are lost in audio
SET compression. ; OFF: Cancels. (Selectable only when playing back a USB device.)
VOL OFFSET –8 to +8 (for AUX) ; –8 to 0 (for other sources): Presets the volume adjustment level of each source.
(Default: 0) (Before adjustment, select the source you want to adjust.)
• [SUB-W LEVEL]/ [SUB-W SET]/ [LPF SUB-W]/ [SUB-W PHASE] is selectable only if [SWITCH PRE] is set to
[SUB-W]. ( 5)
• [SUB-W LEVEL]/ [LPF SUB-W]/ [SUB-W PHASE] is selectable only if [SUB-W SET] is set to [ON].
.
Adjusts the subwoofer output level.
Adjusts the level to memorize for each source. (Before making an adjustment,
select the source you want to adjust.)
Default: XX
11
ENGLISH |