Audio Settings - Kenwood DPX505BT Instruction Manual

Audio Settings

1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected/activated.
4
Press and hold to exit.
(or using the remote control)
1
Press AUD to enter [AUDIO CONTROL].
2 Press J / K to select an item, then press ENT IW.
To return to the previous setting item, press
[AUDIO CONTROL]
[SUB-W LEVEL] [LEVEL –50] to [LEVEL +10] ([LEVEL 0]): Adjusts the subwoofer output
level.
[EASY EQ] Adjusts your own sound settings.
• The settings are stored to [USER] in [PRESET EQ].
• The settings made may affect the current settings of [MANUAL EQ].
[SW]: [LEVEL –50] to [LEVEL +10]
[BASS]: [LEVEL –9] to [LEVEL +9]
[MID]: [LEVEL –9] to [LEVEL +9]
[TRE]: [LEVEL –9] to [LEVEL +9]
26
ENGLISH
[MANUAL EQ]
[PRESET EQ]
.
[BASS BOOST]
Default: [XX]
[LOUDNESS]
[SUBWOOFER SET]
[FADER]
[BALANCE]
(Default: [LEVEL 0]
[LEVEL 0]
[VOLUME OFFSET]
[LEVEL 0]
[LEVEL 0])
Adjusts your own sound settings for each source.
• The settings are stored to [USER] in [PRESET EQ].
• The settings made may affect the current settings of [EASY EQ].
[62.5HZ] [LEVEL]
[BASS EXTEND] [ON]: Turns on the extended bass. ; [OFF]: Cancels.
[100HZ]/[160HZ]/ [LEVEL –9] to [LEVEL +9] ([LEVEL 0]): Adjusts the level to memorize
[250HZ]/[400HZ]/ for each source.
[630HZ]/[1KHZ]/ (Before making an adjustment, select the source you want to adjust.)
[1.6KHZ]/[2.5KHZ]/
[4KHZ]/[6.3KHZ]/
[10KHZ]/[16KHZ]
[Q FACTOR] [1.35]/[1.50]/[2.00]: Adjusts the quality factor.
[NATURAL]/[ROCK]/[POPS]/[EASY]/[TOP40]/[JAZZ]/[POWERFUL]/
[USER]: Selects a preset equalizer suitable to the music genre.
(Select [USER] to use the settings made in [EASY EQ] or
[MANUAL EQ].)
[LEVEL1] to [LEVEL5]: Selects your preferred bass boost level. ;
[OFF]: Cancels.
[LEVEL1]/[LEVEL2]: Selects your preferred low or high frequencies
boost to produce a well-balanced sound at low volume. ;
[OFF]: Cancels.
[ON]: Turns on the subwoofer output. ; [OFF]: Cancels.
[R15] to [F15] ([0]): Adjusts the front and rear speaker output balance.
[L15] to [R15] ([0]): Adjusts the left and right speaker output balance.
[–15] to [+6] ([0]): Presets the initial volume level of each source by
comparing to the FM volume level.
(Before adjustment, select the source you want to adjust.)
[LEVEL –9] to [LEVEL +9] ([LEVEL 0]): Adjusts
the level to memorize for each source.
(Before making an adjustment, select the source
you want to adjust.)