Kenwood KMM-100 Instruction Manual page 15

Basic procedure
Remove the key from the ignition switch, then disconnect the · terminal of the car battery.
1
2
Connect the wires properly. (See Wiring connection. (
3
Install the unit to your car. (See Installing the unit (in-dash mounting).)
Connect the · terminal of the car battery.
4
5
Reset the unit. ( 3)
Installating the unit (in-dash mounting)
Orientate the trim plate as
illustrated before fitting.
When installing without the mounting sleeve
1
Remove the mounting sleeve and trim plate from
the unit.
2
Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
the supplied screws.
How to remove the unit
INSTALLATION / CONNECTION
Bend the appropriate tabs
to hold the mounting sleeve
firmly in place.
Hook on the top side
16))
Do the required
wiring. (
ENGLISH |
16)
Dashboard of
your car
15