Additional Announcements - Honeywell ADEMCO LYNXR User Manual

Additional Announcements:

Pressing STATUS key once will announce the following primary messages, depending on the system's status at the
time:
Disarmed–Ready to Arm [check system]
Disarmed [not ready to arm]
Armed [away] [stay] [instant] [check system] [exit now]
Pressing the STATUS key twice will announce the following secondary messages, depending on the system's status at
the time:
Fire Alarm + zone voice descriptor
Alarm + zone voice descriptor
Fire Fault + zone voice descriptor
NOTE: If there are no secondary messages, the primary status messages will be announced.
LED Meanings
ARMED LED: ON = System armed
(Red) OFF = System disarmed
Blinking = System armed, but a fault exists or
once per second when AVM (VOX or Talk) or
speaker phone mode is active.
Fault + zone voice descriptor
Low Battery + zone voice descriptor
Chime
READY LED:
(Green)
NOTE: When the system is armed, the READY LED turns off.
– 42 –
Zones Bypassed
System Low Battery
AC Loss
ON = System disarmed, ready to arm
Blinking = System disarmed, not ready to arm
(a fault exists) or once per second when AVM
(VOX or Talk) or speaker phone mode is active.