Daikin H-Series Engineering Data page 85

Optional Accessories
2. Securing the remote control adapter
Remove the upper case of the remote control adapter
and secure the lower case assembly.
3. Wiring
Tie-band
(to secure the cord)
Tie-band
(to secure the cord)
(Cord drawn out on the back)
4. Placing the upper case assembly of the remote controller and the upper case of the remote controller adapter back into their original positions
5. Temperature indication change
To change from Celsius temperature indication to Fahrenheit one
Press and hold down
same time for 5 seconds while the
Celsius temperature is indicated.
84
Wood screws (φ3.5mm × 16mm)
(Mounting with supplied wood screws)
Remote control adapter (attached)
To indoor unit S21-HA connector
Connector
Attached
five-wire cord
Remote controller cord
(Note 1)
Lower case
Connector
Remote controller
Remote controller
board
board
Upper case
assembly
(Cord drawn out on the top)
Catch the lower hook first.
During mounting of the remote
controller cord, be careful not to pinch
or otherwise damage the wires.
(Remote controller cord 4 wire)
at the
← See Operation Manual
3P202923-2B
Double-face
adhesive tape
(Mounting with supplied double-face adhesive tape)
Using wire cutters, make
a notch for wiring and
then seal the notch to
ensure it is waterproof.
Note 1) Ground the both ends of the shielded wire.
Remote controller cord 4 wire
Item No.
BRCW901A03
Connector
BRCW901A08
Tie-band
(to secure the cord)
To remote control adapter
EDUS04-924A
Length
Approx. 3m (10ft)
Approx. 8m (26ft)
Room Air Conditioners H-Series