Samsung DVD-HR737 Instruction Manual page 84

• Start/End Time : Start and end time of the timer
recording.
• Mode (Recording Mode) :
- FR (Flexible Recording) : Select when you want to
set video quality automatically. In FR mode, the most
suitable record mode is adjusted automatically,
according to remaining time on the disc and length
of the timer recording. This function is selected only
one mode in XP, SP, LP and EP modes.
- XP (high quality) : Select when video quality is
important.
- SP (standard quality) : Select to record in standard
quality.
- LP (low quality) : Select when a long recording time
is required.
- EP (extended) : Select when a longer recording time
is required.
When you are recording at EP mode on a
I
DVD-RW(V mode)/-R disc, it may not
NOTE
record the full 6 or 8 hours because the
unit uses the VBR(Variable Bit Rate)
ENCODING system. For example, if you
record a programme with a lot of action,
it uses a higher bit rate which in turn consumes
more disc memory.
VPS/PDC
• : VPS(Video Programme System) or
PDC(Programme Delivery Control) function.
- If you set this function on, you can control the starting
and ending time of recording by special signal included
in the broadcasting signal. If a TV programme is
shortened or starts earlier or later than scheduled, this
function synchronizes the starting and ending time of
recording with the actual broadcasting time automatically.
- Set up the start-time EXACTLY according to the
published TV schedule. Otherwise the timer recording
will not operate.
- Do not select PDC or VPS unless you are sure the
programme you wish to record is broadcast with PDC or
VPS.
TITLE
• : To label the title name, select the title and then press
the OK button. Title renaming screen appears.
See page 90 for the registration.
84 - English
5
After selecting the set up value for each mode, press the
OK button to select Save, and press the OK button
again.
• will appear on the front panel. It means that a
timer recording is registered.
If the timer settings overlap;
The programmes are recorded in order of priority.
If timer recording is set for the first programme and
then again for the second programme and both
programmes overlap, the following message will
appear on the screen: "This setting is identical with
1." The message shows that the first programme has
priority. After recording of the first programme is
complete, the second programme starts being
recorded.
To exit without saving the current setting
Press the MENU button.
To return to the previous menu
Press the RETURN button if you don't want to set a
timer recording.
6
When you want to recording on DVD-RW/-R, you must
insert the disc.
7
Turn the power off to finish the Timer Recording
setting.
Timer Recording will not work when the power is on.
The timer recording time may differ from the
I
set time depending on disc status and
NOTE
overall timer recording status (for example,
recording times overlapping, or when the
previous recording ends within 2 minutes
before the start time of the next recording.)
You can make the Timer Recording up to 12
I
programmes.
If HDD disk has no available recording
I
space, blinks. It means that HDD disk has
no space to record.
If you have set the Timer Recording using
I
VPS/PDC, the fan can still operate and
make a noise when the power is off.