Hood Surfaces; Light Bulbs - GE Monogram ZV800 Owner's Manual

Stainless
surface.
steel surfaces
To clean the stainless steel surface, use warm
(on some models)
sudsy water, a stainless steel cleaner such as
Kleen King
cleaner. Always scrub in the direction of the grain.
Rinse thoroughly with a sponge or cloth and clean
water. Dry with a soft, clean cloth.
Painted Clean any painted surfaces with a mixture of
water and either soap or vinegar.
Surfaces
(on some models)
Glass visor Pull the glass visor out and wash it with a damp
soapy cloth. Dry it with a clean cloth and push it
back into place.

Light bulbs

NOTE: The glass cover should be removed only
when cold. Wearing latex gloves may offer a
better grip.
disconnect electrical power to the hood
at the main fuse or circuit breaker panel.
hotte en enlevant le fusible principal ou en faisant
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a hot bulb with
bare hands or a damp cloth.
1 Insert your finger nail into the inner glass
cover slot and pull down. Remove cover.
NOTE: Do not remove outer retaining ring.
2 Using gloves or a dry cloth, remove the bulb
by pulling it straight out.
1 Use a new 12-volt, 20-watt Halogen bulb for a
G-4 base.
2 Using gloves or a dry cloth, remove the new
bulb from its packaging.
NOTE: Do not touch the new halogen bulb
with bare fingers. Touching the bulb with bare
fingers will significantly reduce the life of the
bulb.
or an all-purpose liquid or spray
®
: Before replacing the bulb,
: Avant de remettre
Care and Cleaning
Chimney Vent Hood
After cleaning, use a stainless steel polish, such
as Stainless Steel Magic ® , Revere Copper and
Stainless Steel Cleaner or Wenol All Purpose
®
Metal Polish . Follow the product instructions for
®
cleaning the stainless steel surface.
Do not use commercial oven cleaners, cleaning
powders, steel wool or harsh abrasives on any
painted surface.
Receptacle
Glass cover
Receptacle
Use gloves
or cloth
3 Push the bulb straight into the receptacle all
the way.
For improved lighting, clean the glass cover
frequently using a damp cloth. This should be
done when the hood is completely cool.
4 Snap the glass cover into the retaining ring.
5 Reconnect electrical power to the hood.
Socket
Bulb
7