HP Z800 Maintenance And Service Manual page 188

6. Align the PCI card keyway with the slot key, and then firmly seat the card in the slot as shown in
the following figure (1).
Figure 5-101
7. Close the expansion card retention clamp by rotating it downward (2). The retention clamp is
secured by the expansion card support.
NOTE:
when closed. If the angle is greater than this, open the clamp and ensure that all cards are
properly seated and all the brackets are mated to the chassis, then re-close the clamp.
8. Install the expansion card support (see
9. Reinstall all removed components and reconnect any cables that have been disconnected.
176 Chapter 5 Replacing components
Installing a PCI card
It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle
Installing the expansion card support on page 85).
ENWW