Optical Disk Drive; Removing An Optical Disk Drive From The Optical Drive Bay - HP Z800 Maintenance And Service Manual

Optical disk drive

This section describes how to remove and install an optical disk drive.

Removing an optical disk drive from the optical drive bay

1.
Disconnect power from the workstation (see
2. Remove the side access panel (see
3.
Remove the airflow guide (see
4. Remove the expansion card support (see
5.
Disconnect the power (1) and data (2) cables from the optical disk drive, as shown in the
following figure.
Figure 5-24
100 Chapter 5 Replacing components
Removing the side access panel on page
Removing the airflow guide on page
Disconnecting the optical disk drive cables
Predisassembly procedures on page
Removing the expansion card support on page
77).
79).
80).
82).
ENWW