Installing The Slot Load Optical Disk Drive - HP Z800 Maintenance And Service Manual

Installing the slot load optical disk drive

1. With power off and the side access panel open, remove the expansion card support and any card
cables that might interfere with slot load assembly installation.
2. Remove the airflow guide (see
3. Insert the optical disk drive in the carrier at an angle (1).
Rotate the drive vertical, and then push it down until it snaps into place (2).
Figure 5-34
110 Chapter 5 Replacing components
Removing the airflow guide on page
Install the optical disk drive in the carrier
80).
ENWW