HP Z800 Maintenance And Service Manual page 176

6. Align the DIMM connector key with the DIMM socket key, and then seat the DIMM firmly in the
socket (1), as shown in the following figure.
CAUTION:
DIMM damage, align these guides properly when installing DIMMs.
Figure 5-92
7. Secure the socket levers (1), as shown in the above figure..
8.
Reinstall all removed components and reconnect any cables that have been disconnected.
NOTE:
BIOS errors and warnings on page 159
164 Chapter 5 Replacing components
DIMMs and their sockets are keyed for proper installation. To prevent socket or
Seating the DIMM
If you receive a DIMM-related error message after you re-start the workstation, refer to
for error message information.
ENWW