Installing Wall Mount Dispensers - Follett 25 Installation, Operation And Service Manual

Installing wall mount dispensers

Wall and fasteners must be of sufficient strength to carry weight of unit. Hardware for this is not
!
included.
1. Install supplied wall bracket with six 3/8" diameter fasteners as shown in Fig. 7.
Note: Three holes are available at each fastening site to allow capture of studs/support within wall.
Steps 2 - 3 are required for models with integral ice machine only (25HT400A/W and 50HT400A/W).
2. For models with integral ice machine, use straight edge to position fi ller strip fl ush with top edge of wall bracket.
3. Fasten fi ller strip to wall as shown in Fig. 8.
4. For all models, cut utility hole in wall (Figs. 7 and 8) using wall bracket as template.
5. Lift dispenser onto wall bracket, positioning unit so that hook on back of dispenser is captured by wall bracket
support angle (Fig. 6, hook detail).
!
Do not rest dispenser weight on bottom front edge of wall bracket.
6. Install four 1/4-20 screws through bottom of wall bracket into bottom of dispenser to secure dispenser to bracket.
7. Remove splash panel. Water line to solenoid valve can be disconnected from water inlet valve by pushing on ring
at end of inlet fi tting while pulling on tubing.
Fig. 6 – Side view and angle detail for wall mount units without drain pan with integral ice machine (in top of
cabinet). Wall mount units with RIDE ice machines will not require installation of a fi ller strip.
25CT/HT/CR/HR/FB and 50CT/HT/CR/HR/FB
24"
(610mm)
21.5"
2.5"
(546mm)
(64mm)
17.125"
(435mm)
16.875"
(429mm)
23"
(584mm)
support angle and
18.5"
(470mm)
25HT400A/W
12" (305mm)
50HT400A/W
16" (406mm) 25HT400A/W
44" (1118mm)
50HT400A/W
48" (1219mm)
13.5"
(343mm)
18"
(457mm)
hook detail
11