Panel Removal; Fan Removal - Follett 12 Installation, Operation And Service Manual

Panel removal

Top cover: Lift cover up and off Velcro strips.
splash panel
screw
Splash panel: Remove 2 screws. Pull out bottom
of panel to allow top to slide out from under hopper
support lip.

Fan removal

(a) Remove 4 fan mounting screws
and 3 drain tubes from bracket.
12CI400A • 12HI400A 220 V 60 Hz/230 V 50 Hz Dispensers
top cover
hopper support lip
mounting
screws
drain tube
bracket
(b) Rotate fan mounting bracket
toward back of unit and pull
fan assembly toward front
ofunit.
front cover
screw
Front cover: Remove 2 screws. Lift cover up and
forward to unhook from keyhole slots and clear tabs on
bottom of cover.
screw
LH side
panel
Side panels: Remove screw located on lower rear
side. Pull side panel toward front of unit and out of back
panel. Note: Before removing right hand side, remove
side louver panel by lifting up and pulling forward on
panel.
(c) As fan assembly is being pulled
back panel
RH side panel
screw
louver
panel
toward front, rotate assembly
clockwise as shown above.
31