Panel Removal; Fan Removal - Follett 12 Series Installation, Operation And Service Manual

Panel removal

Top cover: Lift cover up and off Velcro strips.
splash panel
screw
Splash panel: Remove 2 screws. Pull out bottom
of panel to allow top to slide out from under
hopper support lip.

Fan removal

(a) Remove 4 fan mounting screws
and 3 drain tubes from bracket.
top cover
front cover
Front cover: Remove 2 screws. Lift cover up and
forward to unhook from keyhole slots and clear tabs on
bottom of cover.
hopper support lip
Side panels: Remove screw located on lower rear side.
Pull side panel toward front of unit and out of
back panel. Note: Before removing right hand side,
remove side louver panel by lifting up and pulling
forward on panel.
mounting
screws
drain tube
bracket
(b) Rotate fan mounting bracket
toward back of unit and pull
fan assembly toward front of
unit.
30
screw
screw
LH side
panel
(c) As fan assembly is being pulled
toward front, rotate assembly
clockwise as shown above.
back panel
RH side panel
screw
louver
panel