Diamondback 910lc Owner's Manual page 25

You may exit the setup mode and launch the Manual program at any time by pressing the START-STOP key. To continue with
the setup mode and adjust the Calorie setting, press the ENTER key.
Calorie Target Setting. The Calorie value will begin to flash. Adjust the desired calorie target to a value within the range of
10 to 999 via the UP and DOWN arrow keys.
During the program, the displayed calories value will count down from the user's target. The beeper will sound when this
target has been achieved.
You may exit the setup mode and launch the Manual program at any time by pressing the START-STOP key. To continue with
the setup mode and adjust the Watts setting, press the ENTER key.
Watts Target Setting. The Watts value will begin to flash. Adjust the desired Watt generation target to a value within the
range of 10 to 350. Press ENTER to adjust the Watts generation target.
During the program, a graph consisting of an Up Arrow, a Down Arrow and a Circle between them will indicate
the user's current status with regard to the preset Watt target. If the Watts being generated are below the
target, the Down arrow will flash to indicate that the user is not generating enough Watts. The user should
increase their RPM to maintain the Watts target. If the situation continues for more than three (3) minutes,
the monitor will give six beeps, switch itself off, and reset the Watt value back to zero. A flashing circle will
indicate that the Watts target is being achieved.
You may exit the setup mode and launch the Manual program at any time by pressing the START-STOP key. To continue with
the setup mode and adjust the Heart Rate setting, press the ENTER key.
Heart Rate Limit Setting. The Pulse value will begin to flash. Adjust the desired pulse/heart rate target to a value within the
range of 20 to 240 BPM via the UP and DOWN arrow keys. Press ENTER to continue scrolling through the setting loop, or
press START-STOP to launch the program.
During the program, the console will beep to indicate that the user's heart rate is equal to or greater than the pulse/heart
rate limit setting. The user should decrease their pedaling speed.
Program Launch. Press the START-STOP key to launch the program.
Pause. To pause the program, press the START-STOP key. To return to program run mode, press the START-STOP key again.
910Ic Owner's Manual
25