Diamondback 910lc Owner's Manual page 23

910Ic Owner's Manual
Reset
You can reset all of the values back to zero by holding the START/STOP key down for 3 seconds. This action will erase all save
data, including user-defined workout profiles.
Program Selection Mode
After powering up, the console will enter the main screen or program selection mode, where the program titles will be flashing.
Use the UP or DOWN arrow keys to highlight the desired program and press the ENTER key launch the program setup mode for
the selection.
Program Options
The 910Ic offers four program categories: MANUAL, H.R.C. (Heart
Rate Control), PROGRAM (Preprogrammed Profiles) and USER
(User Defined/Custom). Within these categories, H.R.C and
PROGRAM offer several options (see the chart to the right). When
the unit is powered on, the small cluster of program titles on the
LCD display will flash, prompting the user to make a selection.
QuickStart
If the START-STOP key is pressed while the main screen is displayed, the console will QuickStart the Manual program, bypassing
all user setting adjustments and accept the default values.
Change Programs
While in program run mode, to change from one category or program to another, pressing the START-STOP key will pause the
current program. Press RESET to return to the program selection mode (See section titles Program Selection Mode).
23