Vipersat Migration; Udp Port Base Address; Figure 3-63 Vipersat Migration Prompt - Comtech EF Data Vipersat 564L User Manual

V i p e r s a t C o n f i g u r a t io n

Vipersat Migration

The Vipersat Migration command is used to set the compatibility mode for the
Hub Burst Controller when conducting a firmware upgrade on the associated
Remotes. Although this command appears in the menu for both the Hub modem
and the Remote modem, it only applies to STDMA Controllers and TDM
Outbound modems at the Hub.
Enter M at the command prompt in the Vipersat Configuration screen to
display the Vipersat Migration dialog shown in figure 3-63.
Figure 3-63
Vipersat Migration prompt
Refer to Appendix D, "Network Migration", in this document for additional
information on the use of this command.

UDP Port Base Address

Should a particular network application require a specific UDP port base
address be used, the default address can be changed by entering U at the
command prompt in the Vipersat Configuration screen (figure 3-6).
C h ap t e r U s i n g t h e C o m m a n d L in e I n t e r f a c e ( C L I )
3 - 3-49