Table of Contents
Advertisement
F i r m w a r e U p g r a d e
3) Save to Flash on all units and reset them to Latest/Oldest.
4) "Get Information" (VLOAD needs current information before performing
each step).
5) Upgrade Bulk Image location #1 on the Base Modem to v1.4.5 and reset all
boxes to "Latest" code. Note this is only necessary if unit is running < v1.4.4.
6) "Get Information" and load v1.5.1 Base Modem code to "Oldest" and reset
all the modems to "Latest".
7) Load v1.5.1 Base Modem code to "Oldest" (replacing the older image in the
other location).
8) Load v1.5.3 Router firmware to the "Oldest" Bulk Image.
Migration Procedure
Configure Upgrade Image
Telnet into each unit and use the CLI to set the Upgrade Image to "Oldest":
From the Main Menu, enter O for Operations and Maintenance.
1.
D-4
Figure D-1
Firmware Migration Stages—CDM-570
V i p e r s a t C D D - 5 6 X S e r i e s U s e r G u i d e
Advertisement
Table of Contents
