Configuring Bandwidth Profiles - Cisco Small Business RV220W Administration Manual

Configuring Quality of Service

Configuring Bandwidth Profiles

Configuring Bandwidth Profiles
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco RV220W Administration Guide
Using bandwidth profiles, the bandwidth of the traffic flowing from the secure
network (LAN) to the insecure network (WAN) can be shaped. Bandwidth limiting
determines the speed from which the data is sent from your router. You can use a
bandwidth profile to limit the outbound traffic, thus preventing the LAN users from
consuming all of the bandwidth of the Internet link.
Bandwidth profiles configuration consists of enabling the bandwidth control
feature from the Device Manager, and adding a profile which defines the control
parameters. The profile can then be associated with a traffic selector, so that
bandwidth profile can be applied to the traffic matching the selectors.
To configure bandwidth profiles, perform the following steps.
Enable Bandwidth Profiles
Choose QoS > Bandwidth Profiles.
Check the Enable box.
Click Save.
Add Profiles
In the Bandwidth Profiles Table, click Add.
Enter the Profile Name, or the name used to identify and associate the profile to
traffic selection criteria.
Choose the Profile Type: Priority (to limit bandwidth by high, medium, or low
priority) or Rate (to limit bandwidth by the transmission rate.
If you chose Priority, enter the priority for this profile (low, medium, or high). If you
chose Rate, enter the minimum and maximum bandwidth rates in kilobytes per
second.
Click Save.
6
133