GE JKP77G Use And Care Manual page 52

.
~~e k%vbki'Tl SOiV~~ (continued)
Conventional Oven
PROBLEM
POSSIBLE CAUSE AND REMEDY
OVEN WILL NOT OPERATE
Plug on cooking center not completely inserted into outlet receptacle.
Circuit breaker in your house has tripped or fuse has blown.
Oven controls not properly set.
Door left in locked position after cleaning.
Light bulb is loose or bulb is burned out.
Switch operating oven light is defective.
ELECTRONIC TOUCH PADS Clock not set. Touch CLOCK pad and enter time.
WILL
NOT WORK
ELECTRONIC DISPLAY PANEL If it cannot be reset by touching pads, electrical sewice to your resi-
GOES BLANK OR BLINKS dence has caused interference signals on the main power line. Dis-
connect your cooking center at the main fuse or circuit breaker panel.
Wait one minute and reconnect power. Reset clock.
FOOD DOES NOT
BROIL and START pads not touched.
BROIL PROPERLY
If using a lower broil rate, the correct number from 1-5 was not
touched after BROIL.
Probe not fully inserted into the oven receptacle or food when using
Cooking Code Control.
Improper shelf position is being used.
F~od is being cooked on
a
hot pan.
Utensils are not suited for broiling.
Aluminum foil used on the broil rack has not been fitted properly and
s!it.
FOOD DOES NOT ROAST
BAKE and START pads not touched.
PROPERLY
Oven temperature not set correctly. Incorrect number pads touched.
Probe not fully insectedinto the oven receptacle or food when using
Cooking Code Control.
Shelf position is incorrect. '
Roasting pan is too small.
Improper cookware is being used.
A foil tent was not used when needed to slow down browning.
FOOD DOES NOT BAKE
BAKE and START pads not touched.
PROPERLY
Oven shelf is not level.
Shelf is not on correct shelf position.
The wrong cookware is being used.
Too
many utensils in the oven.
Temperature
setting is incorrect.
52
.—. ..——.. __
—— ——.—.—.——— ...——. ——— —. ---- ___ .— .—.