Table of Contents
Advertisement
GB
2-04-2002
8:01
Pagina 28
3. Setting up the appliance
for steam cleaning
Steam extraction cleaner
Remove rear cover (11), unscrew boiler cap (12) and fill
the chamber with water without adding any detergent
(the particular shape of the cap seat allows filling without
the use of a funnel). Remove any water residue from the
cap cavity, secure cap and rear cover.
Fit the machine with flexible hose (28), extension tubes
(29) and brush nozzle (30) following the assembly
instructions for the tubes, hose, and brush container in
chapter 2.
Connect the plug of the power cord to the mains, press
on/off button (15) and boiler power button (16). At this
point, indicator lights (17 – power) and (18 boiler on) and
will come on . When the steam-ready light (19) comes
on, your cleaner is ready for use.
For steam output, keep button (25) under the handgrip
of the flexible hose pressed and release when you want
to stop steam output. Start suction by pressing the
ON/OFF button (23), in this way the appliance will wash
and vacuum at the same time. In case of stubborn
stains, first steam and then vacuum the area (See
section on "Extraction cleaning technique", p. 30.)
N.B.: When the appliance is used for the first time, it
may give off a particular smell for a few minutes due
to heating and the consequent drying of the
sealants used in assembling the boiler.
28
Advertisement
Table of Contents
