Table of Contents
Advertisement
GB
2-04-2002
8:01
Pagina 29
When the water in the boiler is about to run out, the
water out indicator light (20) will come on. Fill the tank as
follows:
Switch off the appliance by pressing button (15) and the
boiler by pressing button (16). Disconnect from the
mains. Wait for 10-15 minutes until the appliance has
cooled down, then place a cloth over cap (12) and
unscrew slowly allowing residual steam to escape
gradually. Proceed to fill the chamber again as described
above.
Important notice! Never unscrew cap with the boiler
under pressure and never operate it without water.
Steam adjustment knob (21)
(only for some models)
Use to adjust steam output.
Keep the knob on the maximum steam output setting
when switching on the appliance.
Pressure gauge (22)
(only for some models)
Allows you check the pressure in the boiler.
Depending on the model, the manometer has a
graduated 0-6 bar scale or coloured segments:
-
The normal operating pressure of the appliance is
around 3 - 4 bars (green segment).
-
If the pressure remains above 5 bars or around 0
(red or yellow segment), contact an authorised
Service Centre.
29
Advertisement
Table of Contents
