Table of Contents
Advertisement
GB
2-04-2002
8:01
Pagina 25
To activate vacuuming, press Suction button ON/OFF
(23) on the handgrip of the flexible hose. The appliance
will be reach maximum vacuuming power in a few
seconds. To disactivate suction, press Suction button
ON/OFF (23) once more.
To decrease or increase suction power, press button (24)
keeping it depressed until the desired suction power has
been reached.
N.B.: Do not press button (16) to power the boiler
when the appliance is used for vacuuming only.
Important notice: during wet vacuuming, when tank
(2) is full, a special device will shut suction off and the
motor will rev up. At this point, switch off the
appliance by pressing button (15), disconnect it from
the mains, and empty out the wet/dry tank. The
above device will be activated also when filters (7)
and (4) are exhausted – in this case, remove them
and clean them (see chap. 4)
The suction shut-off device may be triggered off also
by any violent impact or shock to the machine. In this
case, switch the motor off and wait a few seconds
before starting the machine once again.
25
Advertisement
Table of Contents
