DeLonghi XVT 7000 User Manual page 4

GB 2-04-2002 8:01 Pagina 23
2. Setting up the appliance
for dry/wet vacuuming
Open the front cover (1) by pulling trigger (10) placed
under the handle of the appliance.
Remove the water tank by pulling the trigger and at the
same time lifting the tank by the handle (6).
By means of the hooks, remove the tank cover with float sy-
stem.
To extract the cover correctly, position the thumbs inside
1
the central cavity in contact with the two projecting edges of
the tank.
Press on the two projecting edges to facilitate release of the
cover tooth from the slot.
Use the handle to facilitate extraction of the cover from the
front lock.
2
Press on the bottom of the front locking device to free the
tooth from the slot.
You can also act on the top of the hook to facilitate the ope-
ration. Lift the cover and empty the tank.
Remove the air flow conveyer (3) and pour water into the
tank until the two projections on the base of the tank are co-
vered (about 800 cc)
Re-insert the air flow conveyer, to its original position. Re-
place the tank cover pressing down firmly to ensure the co-
ver is locked in position. Hold down the trigger (10) and re-
place the tank to its final position. Close the cover.
N.B.: No water is necessary if the appliance is going
to be used for wet vacuuming.
23