DeLonghi XVT 7000 User Manual page 3

Table of Contents

Advertisement

GB
2-04-2002
8:01
24) Do not use the appliance without the polyurethane filter fitted over the float holder.
25) Water is always necessary if the appliance is going to be used for dry vacuuming.
26) Be especially careful when using the appliance on stairs
27) Keep away from children or persons unfit to use it.
28) Do not use the appliance if it seems defective. Return it to the place of purchase or
contact an authorized Technical Service Centre.
29) If the overheating safety control is activated, the iron and controls will cease to
function. The appliance can only be re-set by an authorized Technical Service Cen-
tre.
30) Do not expose the appliance to atmospheric agents (rain, frost, sun, etc.)
31) The noises produced when the boiler heats up or cools down are due to the normal
dilation of the stainless steel with which it is made.
32) For all repairs apply only to the place of purchase or to an authorized Technical
Service Centre, this is to maintain the effectiveness of your appliance and the vali-
dity of the guarantee. For the same reason, use only original parts.
33) Always have the power cord replaced at an Authorized Service Centre only.
KEEP THESE INSTRUCTIONS
The manufacturer reserves the right to modify the appliance and/or accessories without
prior notice.
This appliance is manufactured to comply with the current legislation on electrical safety
and electromagnetic compatibility.
ELECTRICAL CONNECTION (UK ONLY)
A)
If your appliance comes fitted with a plug, it will incorpora-
te a 13 Amp fuse. If it does not fit your socket, the plug
should be cut off from the mains lead, and an appropriate
plug fitted, as below.
WARNING: Very carefully dispose of the cut off plug af-
ter removing the fuse: do not insert in a 13 Amp socket
elsewhere in the house as this could cause a shock ha-
zard.
With alternative plugs not incorporating a fuse, the cir-
cuit must be protected by a 15 Amp fuse.
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with
the following code:
Green and yellow:
Blue:
Brown:
Pagina 22
Earth
E
Neutral
L
Live
N
If the plug is a moulded-on type, the fuse cover must be re-
fitted when changing the fuse using a 13 Amp Asta ap-
proved fuse to BS 1362. In the event of losing the fuse co-
ver, the plug must NOT be used until a replacement fuse
cover can be obtained from your nearest electrical dealer.
The colour of the correct replacement fuse cover is that as
marked on the base of the plug.
B)
If your appliance is not fitted with a plug, please follow
the instructions provided below:
As the colours of the wires in the mains lead may not corre-
spond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The green and yellow wire must be connected to the terminal
in the plug marked with the letter E or the earth symbol
or coloured green or green and yellow.
The blue wire must be connected to the terminal marked with
the letter N or coloured black.
The brown wire must be connected to the terminal marked
with the letter L or coloured red.
22

Advertisement

Table of Contents
loading

Table of Contents