Pull Tractor Unit - Epson LQ-300 User Manual

14. Slide the left edge guide of the paper guide to the center
until it stops at the diamond-shaped guide mark. Then
slide the right edge guide to the opposite guide mark.
You can easily switch between continuous paper and cut-sheet
feeder operation. See " Switching back to single sheets" on page
2-12 for details.
Note:
When you print several pages of continuous paper, fold the first
printed page forward at the perforation after it emerges from
below the printer cover. This helps the printer feed the printed
pages properly and prevents paper jams.
To remove the paper guide from the cut-sheet feeder, press both
release tabs and pull out the paper guide.

Pull Tractor Unit

An additional pull tractor (C80030 ) is available as an option.
You can improve the performance of continuous paper
handling by using two tractors at the same time. This is
especially useful with continuous pre-printed forms, multi-part
forms, and labels.
1. Make sure the paper-release lever is pulled forward to the
continuous paper position. Install the built-in tractor in the
push tractor position. Install the optional tractor in the pull
tractor position. See page 2-13.
2. Load continuous paper on the sprocket units of the push
tractor. (See " Printing on Continuous Paper" on page 2-7.)
3. Turn on the printer. Hold down the LF/FF button to feed
paper forward one page.
Using the Printer
2-33