Table of Contents
Advertisement
Compass
On models without navigation system
Compass Operation
Compass operation can be affected
by driving near power lines or
stations, across bridges, through
tunnels, over railroad crossings, past
large vehicles, or driving near large
objects that can cause a magnetic
disturbance. It can also be affected
by accessories such as antennas and
roof racks that are mounted by
magnets.
Compass Zone Selection
In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
1.
Press and hold the
and
buttons simultaneously until
the temperature display changes
(about 5 seconds).
228
2.
Verify the zone for your area on
the map on page
230
.
3.
Press the
button to cycle the
count down, or the
button to
cycle the count up. Once the
correct zone is displayed, continue
to step 4.
4.
Press the OFF button to save the
zone selection.
5.
To exit the zone setting mode,
either press the
button and
button simultaneously for
about 5 seconds, or press any
climate control button on either
side of the display other than the
or
button.
Advertisement
Chapters
Table of Contents
