Operation - Dimplex DF2690 Owner's Manual

Plug the unit into a 15 Amp, 120 Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 Watts.
existing Fireplace
1. Seal all drafts and vents with a non-fibrous insulation material to
prevent any chimney debris from falling onto the fireplace. Do not
install into an existing fireplace that is prone to dampness.
2. Cap the top of the chimney flue to prevent rain from entering.
3. Plan your electric power supply.
4. The power cord can run along the front of the hearth to an outlet
near the fireplace.
cAuTiON: Clearance for air circulation beneath the fireplace insert
is provided by two spacers. Do not install the fireplace insert
directly on carpet or similar surfaces which may restrict air
circulation. If installing the fireplace in a carpeted area, place a
one-piece, solid, flat surface under the fireplace insert. Ensure that
all three of the insert's feet rest securely on this surface.
For Bathroom use
If this unit is installed in a bathroom it must be protected by a GFI
receptacle or circuit. If receptacle is used it must be readily accessible.
To prevent electrical shock this unit is an electrical appliance that is not
watertight and must be installed as to prevent water from entering unit.
This must be installed away from showers, tubs, etc. Never locate
fireplace where it may fall into a bathtub or other water container. High
temperatures may be generated under certain abnormal conditions.
Do not partially or fully cover or obstruct the front of this heater.

Operation

electric Fireplace Manual control
The manual controls for the fireplace are behind the access panel
located at the bottom of the fireplace (Figure 6).
A. Flame Action control
Turn the flame action control knob to adjust the flame speed to the
desired level.
10