Site Selection And Preparation - Dimplex DF2690 Owner's Manual

5. Place the Front Glass onto the track of the fireplace (Figure 3) and
slide it along the front until it reaches the far left of the unit.
6. Re-attach the right hand trim piece using the four (4) Philips screws
from step 4.

Site Selection and Preparation

This section provides instructions for selecting a location and preparing
the site to install the fireplace into your Dimplex mantel surround.
1. Select a suitable location that is not susceptible to moisture and
is away from drapes, furniture and high traffic.
2. For ease of electrical hook up you may wish to locate the
fireplace near an existing outlet (refer to NOTE 1).
3. Store the fireplace in a safe dry and dust free location.
cAuTiON: Clearance for air circulation beneath the fireplace
is provided by two spacers. Do not install the fireplace insert
directly on carpet or similar surfaces which may restrict air
circulation. If installing the fireplace in a c arpeted area, place a
one-piece, solid flat surface under the fi replace. Ensure that all feet
rest securely on this surface.
!
NOTe: The dimensions of the fireplace with the trim are 27 ⅜
inch (695 mm) wide X 23 ½ inch (596 mm) high X 8 3/4 inch (222
mm) deep. Dimensions without trim are 26 ¼ inch (663 mm) wide
X 22 ⅞ inch (580 mm) high X 8 ¾ inch (222 mm) deep. The
fireplace does not require any additional venting (Figure 4).
Figure 4
(695 mm)
22 ⅞"
(580
mm)
27 ⅜"
(596 mm)
23 ½"
8
26 ¼"
(663 mm)
(222 mm)
8 ¾"