Maintenance - Dimplex DF2690 Owner's Manual

Remote control usage
The remote control operates the fireplace levels sequentially, flames
only to flames and low heat, to flames and high heat. The level is
increased every time the ON button on the transmitter is pressed. The
fireplace can be turned off at any point by pressing the OFF button on
the remote control transmitter.
Level 1: The flame effect is turned on and the first red indicator light
turns on.
Level 2: The flame effect remains on, the heater is activated to the
low heat setting, and the first and second red indicator lights turn
and remain lit.
Level 3: The flame effect remains on, the heater is set to the high heat
setting, and all three red indicator lights remain lit.
Battery Replacement
To replace the battery:
1. Slide battery cover open on the hand held transmitter (Figure 7).
2. Correctly install one (1) 12 Volt (A23) battery in the battery holder.
3. Close the battery cover.

Maintenance

WARNiNG: Disconnect the power before attempting any
maintenance or cleaning to reduce the risk of fire, electric shock or
damage to persons.
Light Bulb Replacement
Allow at least five (5) minutes for the light bulbs to cool before touching
them to avoid accidental burning of the skin. The light bulbs need
to be replaced when you notice a dark section of the flame or when
the clarity and detail of the log ember bed exterior reduces. There
are three (3) bulbs under the log set, which generate the flames and
embers, and two (2) bulbs above the log that illuminate the log exterior.
Helpful Hints
It is a good idea to replace all light bulbs at one time if they are close to
13