Pro-Form XP 210 U User Manual page 11

11. Have a second person hold the Handlebar (47)
near the Upright (3).
Locate the Pulse Wire (52) in the Handlebar
(47). Insert the Pulse Wire into the large hole in
the Upright (3), and then pull the Pulse Wire out
of the top of the Console Plate (19).
Attach the Handlebar (47) and the Console
Plate (19) to the Upright (3) with two M8 x 25mm
Screws (44) and two M8 Curved Washers (8).
12. The Console (6) can use four D batteries (not
included); alkaline batteries are recommended.
Do not use old and new batteries together or
alkaline, standard, and rechargeable batter-
ies together. IMPORTANT: If the Console has
been exposed to cold temperatures, allow it
to warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic com-
ponents. Remove the screws and the battery
covers from the back of the Console, and insert
batteries into the battery compartments. Make
sure to orient the batteries as shown by the
diagrams inside the battery compartments.
Then, reattach the battery covers.
To purchase an optional power adapter, call
the telephone number on the cover of this
manual. To avoid damaging the console,
use only a manufacturer-supplied regulated
power adapter. Plug one end of the power
adapter into the receptacle inside the battery
compartment on the console; plug the other end
into an outlet installed in accordance with all
local codes and ordinances.
11
47
8
44
12
Battery
Cover
6
11
19
52
3
Battery
Cover
Receptacle